Front Suspension Lower No. 1 Arm
FRONT SUSPENSION LOWER NO. 1 ARMCOMPONENTS:
REMOVAL
HINT:
^ Use the same procedures for the RH side and the LH side.
^ The procedures listed below are for the LH side.
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
HINT: Refer to the instructions for installation of the engine assembly.
2. REMOVE ENGINE MOUNTING INSULATOR
(a) Remove the 3 nuts and the engine mounting insulator.
3. REMOVE FRONT SUSPENSION LOWER NO. 1 ARM
(a) Remove the 3 bolts and the nut on the front suspension lower No. 1 arm and remove it from the front frame assembly.
(b) Remove the front lower arm bushing stopper.
INSTALLATION
1. INSTALL FRONT SUSPENSION LOWER NO. 1 ARM
(a) Install the front lower arm bushing stopper.
(b) Install the front suspension lower No. 1 arm to the front frame assembly with the 3 bolts and the nut, but do not tighten them yet.
(c) Tighten the 3 bolts in numerical order shown in the illustration.
Torque: 200 N*m (2,040 kgf*cm, 148 ft.*lbf) (bolt A)
206 N*m (2,100 kgf*cm, 152 ft.*lbf) (bolt B)
2. INSTALL ENGINE MOUNTING INSULATOR
(a) Install the engine mounting insulator with the 3 nuts.
Torque: 87 N*m (887 kgf*cm, 64 ft.*lbf)
3. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
HINT: Refer to the instructions for removal of the engine assembly.