Park / Neutral Position Switch Circuit
Park / Neutral Position Switch CircuitDESCRIPTION
The park/neutral position switch detects the shift lever position and sends signals to the TCM.
WIRING DIAGRAM:
INSPECTION PROCEDURE
1. DATA LIST
HINT: According to the DATA LIST displayed on the intelligent tester, you can read the value of switches, sensors, actuators and other items without removing any parts. Reading the DATA LIST as the first step in troubleshooting is one method to save labor time.
NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty.
(a) Warm up the engine.
(b) Turn the engine switch off.
(c) Connect the intelligent tester together with the CAN VIM (Controller Area Network Vehicle Interface Module) to the DLC3.
(d) Turn the engine switch on (IG).
(e) Turn on the tester.
(f) Enter the following items: "DIAGNOSIS / OBD/MOBD / ECT / DATA LIST".
(g) According to the display on the tester, read "DATA LIST".