Radio/Stereo: Service and Repair

Radio Receiver:

RADIO RECEIVER

REMOVAL

1. SET RADIO RECEIVER ASSEMBLY TO SHIPMENT MODE
a. Remove all discs and tapes.

NOTE: If the discs or tapes cannot removed, do not attempt to remove them forcibly. Send the unit to a repair shop.

b. Turn the engine switch off.







c. While simultaneously pressing the "SEEK UP" and "DISC" switches, turn the engine switch on (ACC).

HINT: The CD loading door indicator light blinks during mode setting and it remains lit after the setting is completed.

d. Turn the engine switch off.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

3. REMOVE FRONT CONSOLE UPPER PANEL GARNISH
4. REMOVE CONSOLE UPPER PANEL ASSEMBLY
5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH

7. REMOVE MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY




a. Remove the 4 bolts.




b. Pull the multi-display with radio receiver to detach the 2 clips on the backside of the multi-display.
c. Disconnect the connectors and remove the multidisplay with radio receiver.

8. CONFIRM RADIO RECEIVER ASSEMBLY SHIPMENT MODE SETTING




a. Look at the backside of the radio receiver and check that a metal plate can be seen through the hole near the "SHIP" mark.

NOTE: If a metal plate cannot be seen, perform the shipment mode setting again.

9. REMOVE NO. 2 RADIO BRACKET




a. Remove the 5 bolts and bracket.

10. REMOVE NO. 1 RADIO BRACKET




a. Remove the 5 bolts and bracket.

11. REMOVE MULTI-DISPLAY
12. REMOVE RADIO RECEIVER ASSEMBLY

INSTALLATION

HINT: A bolt without a torque specification is given in the standard bolt chart.

1. INSTALL NO. 2 RADIO BRACKET




a. Install the bracket with the 5 bolts.

2. INSTALL NO. 1 RADIO BRACKET




a. Install the bracket with the 5 bolts.

3. INSTALL MULTI-DISPLAY WITH RADIO RECEIVER ASSEMBLY
a. Connect the connectors.




b. Insert the multi-display with radio receiver and attach the 2 clips on its backside.




c. Install the multi-display with radio receiver with the 4 bolts.

4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
6. INSTALL CONSOLE UPPER PANEL ASSEMBLY
7. INSTALL FRONT CONSOLE UPPER PANEL GARNISH
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

9. PERFORM INITIALIZATION
a. Perform initialization. Testing and Inspection

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.