Cruise Control Switch: Service and Repair

Cruise Control Main Switch:

CRUISE CONTROL MAIN SWITCH

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE STEERING WHEEL NO. 2 COVER LOWER
3. REMOVE STEERING WHEEL NO. 3 COVER LOWER
4. REMOVE STEERING WHEEL PAD
5. REMOVE STEERING WHEEL ASSEMBLY For 3GR-FSE For 3UZ-FE

6. REMOVE CRUISE CONTROL MAIN SWITCH




a. Disconnect the connector.
b. Remove the 2 screws and switch.

INSTALLATION

1. INSTALL CRUISE CONTROL MAIN SWITCH




a. Install the switch with the 2 screws.

Torque: 1.7 to 3.0 N.m (17 to 31 kgf.cm, 15 to 27 in.lbf)

b. Connect the connector.

2. INSTALL STEERING WHEEL ASSEMBLY For 3GR-FSE For 3UZ-FE
3. INSTALL STEERING WHEEL PAD
4. INSTALL STEERING WHEEL NO. 3 COVER LOWER
5. INSTALL STEERING WHEEL NO. 2 COVER LOWER
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
7. PERFORM INITIALIZATION

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal. Perform initialization.

8. CHECK SRS WARNING LIGHT Check the SRS warning light.