Headlamp Bulb: Service and Repair

High Intensity Discharge Headlight Bulb:

HIGH INTENSITY DISCHARGE HEADLIGHT BULB

REMOVAL

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE ENGINE ROOM SIDE COVER
4. REMOVE NO. 1 HEADLIGHT BACK COVER
5. REMOVE HIGH-INTENSITY DISCHARGE HEADLIGHT BULB

INSTALLATION

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed are for the LH side.

1. INSTALL HIGH-INTENSITY DISCHARGE HEADLIGHT BULB
2. INSTALL HEADLIGHT NO. 1 BACK COVER
3. INSTALL ENGINE ROOM SIDE COVER
4. INSTALL COOL AIR INTAKE DUCT SEAL
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.