Heated Oxygen Sensor (For Sensor 2)
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH
3. REMOVE FRONT ASH RECEPTACLE ASSEMBLY
4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH
5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
6. REMOVE HEATED OXYGEN SENSOR (for Bank 1)
a. Disconnect the sensor connector.
b. Disconnect the grommet and pull the sensor connector out of the cabin through the floor panel.
c. Using SST, remove the sensor.
SST 09224-00010
7. REMOVE HEATED OXYGEN SENSOR (for Bank 2)
a. Disconnect the sensor connector.
b. Disconnect the grommet and pull the sensor connector out of the cabin through the floor panel.
c. Using SST, remove the sensor.
SST 09224-00010
INSTALLATION
1. INSTALL HEATED OXYGEN SENSOR (for Bank 1)
a. Using SST, install the sensor.
SST 09224-00010
Torque:
40 N.m (408 kgf.cm, 30 ft.lbf) for use with SST
44 N.m (449 kgf.cm, 32 ft.lbf) for use without SST
HINT: Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
b. Pass the sensor connector through the floor panel and into the cabin, and install the grommet.
c. Connect the sensor connector.
2. INSTALL HEATED OXYGEN SENSOR (for Bank 2)
a. Using SST, install the sensor.
SST 09224-00010
Torque:
40 N.m (408 kgf.cm, 30 ft.lbf) for use with SST
44 N.m (449 kgf.cm, 32 ft.lbf) for use without SST
HINT: Use a torque wrench with a fulcrum length of 300 mm (11.81 in.).
b. Pass the sensor connector through the floor panel and into the cabin, and install the grommet.
c. Connect the sensor connector.
3. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
4. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
5. INSTALL FRONT ASH RECEPTACLE ASSEMBLY
6. INSTALL FRONT CONSOLE UPPER PANEL GARNISH
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.