Removal and Replacement

Engine Switch:

ENGINE SWITCH

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.

2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH
3. REMOVE FRONT CONSOLE UPPER PANEL ASSEMBLY
4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
5. REMOVE FRONT DOOR SCUFF PLATE LH
6. REMOVE FRONT DOOR OPENING TRIM COVER
7. REMOVE INSTRUMENT SIDE PANEL LH
8. REMOVE INSTRUMENT PANEL NO. 1 SAFETY PAD SUB-ASSEMBLY
9. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
10. REMOVE INSTRUMENT PANEL NO. 1 UNDER COVER SUB-ASSEMBLY




11. REMOVE ENGINE SWITCH
a. Disconnect the switch connector.
b. Detach the 2 claws and remove the switch.

INSTALLATION




1. INSTALL ENGINE SWITCH
a. Attach the 2 claws and install the switch.
b. Connect the switch connector.

2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY
3. INSTALL INSTRUMENT PANEL NO. 1 UNDER COVER SUB-ASSEMBLY
4. INSTALL INSTRUMENT PANEL NO. 1 SAFETY PAD SUB-ASSEMBLY
5. INSTALL INSTRUMENT SIDE PANEL LH
6. INSTALL FRONT DOOR OPENING TRIM COVER LH
7. INSTALL FRONT DOOR SCUFF PLATE LH
8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
9. INSTALL FRONT CONSOLE UPPER PANEL ASSEMBLY
10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

12. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

13. CHECK SRS WARNING LIGHT
a. Check the SRS warning light