Wiper Switch: Service and Repair

Wiper Switch:

WIPER SWITCH

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3. REMOVE NO. 3 STEERING WHEEL COVER LOWER
4. REMOVE NO. 2 STEERING WHEEL COVER LOWER
5. REMOVE STEERING PAD
6. REMOVE STEERING WHEEL ASSEMBLY
7. REMOVE STEERING COLUMN COVER
8. REMOVE SPIRAL CABLE WITH STEERING SENSOR




9. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
a. Disconnect the connector.
b. Detach the claw and remove the wiper switch.

NOTE: If the claw is pushed with excessive force, it may break.

INSTALLATION




1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
a. Attach the claw and install the wiper switch.
b. Connect the connector.

2. INSTALL SPIRAL CABLE WITH STEERING SENSOR
3. INSTALL STEERING COLUMN COVER
4. ADJUST SPIRAL CABLE WITH STEERING SENSOR
5. INSTALL STEERING WHEEL ASSEMBLY
6. INSPECT STEERING WHEEL CENTER POINT
7. INSTALL STEERING PAD
8. INSTALL NO. 3 STEERING WHEEL COVER LOWER
9. INSTALL NO. 2 STEERING WHEEL COVER LOWER
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. INSPECT STEERING PAD

12. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

13. INSPECT SRS WARNING LIGHT
a. Check the SRS warning light.