Initialization Not Completed
DTC C2177/77 Initialization not CompletedDESCRIPTION
The initialization procedure will start when the tire pressure warning reset switch is pressed for 3 seconds or more with the power switch in the ON (IG) position.
The tire pressure warning ECU will register the tire pressure data by the signals from the tire pressure warning valve and transmitter, and blink the tire pressure warning light 3 times at 1 second intervals.
C2177/77:
INSPECTION PROCEDURE
NOTICE:
^ If the registered set of the tires and wheels does not correspond to the selection of the tire pressure warning select switch (MAIN/2nd), DTC C2172/72 will be output.
^ When replacing the tire pressure warning ECU, read the IDs stored in the ECU using the intelligent tester and note them down before removal.
^ It is necessary to perform initialization after registration of the transmitter IDs into the tire pressure warning ECU after the ECU and/or valve and transmitter has been replaced.
HINT:
Set the tire pressure to the specified value.
Standard pressure: 240 kPa (2.4 kgf/cm2, 35 psi)
Step 1(Part 1):
Step 1(Part 2):
