Antilock Brakes / Traction Control Systems: Service and Repair
REMOVAL1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE LUGGAGE COMPARTMENT FLOOR MAT
a. Remove the floor mat.
3. REMOVE LUGGAGE COMPARTMENT NO. 1 TRIM COVER
a. Remove the trim cover.
4. REMOVE ROPE HOOK ASSEMBLY
a. Remove the 2 bolts and 2 rope hooks.
5. REMOVE REAR FLOOR FINISH PLATE
a. Remove the 3 clips and finish plate.
6. REMOVE ROPE HOOK
a. Remove the 2 rope hooks.
7. REMOVE LUGGAGE COMPARTMENT NO. 2 TRIM HOOK
a. Remove the 2 trim hooks.
8. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER
a. Remove the 4 clips and trim cover.
9. REMOVE SIDE LUGGAGE COMPARTMENT TRIM COVER RH
a. Remove the bolt and rope hook.
b. Remove the 2 clips and trim cover.
10. REMOVE BRAKE CONTROL POWER SUPPLY ASSEMBLY
a. Disconnect the connector.
b. Remove the 3 nuts and brake control power supply.
c. Remove the 4 bolts and 2 brackets.
INSTALLATION
1. INSTALL BRAKE CONTROL POWER SUPPLY ASSEMBLY
a. Install the 2 brackets with the 4 bolts.
Torque: 13.5 N.m (138 kgf.cm, 10 ft.lbf)
b. Install the brake control power supply with the 3 nuts.
Torque: 17 N.m (173 kgf.cm, 13 ft.lbf)
c. Connect the connector to the brake control power supply.
2. INSTALL SIDE LUGGAGE COMPARTMENT TRIM COVER RH
a. Install the trim cover with the 2 clips.
b. Install the rope hook with the bolt.
3. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER
a. Install the trim cover with the 4 clips.
4. INSTALL LUGGAGE COMPARTMENT NO. 2 TRIM HOOK
a. Install the 2 trim hooks.
5. INSTALL ROPE HOOK
a. Install the 2 rope hooks.
6. INSTALL REAR FLOOR FINISH PLATE
a. Install the finish plate with the 3 clips.
7. INSTALL ROPE HOOK ASSEMBLY
a. Install the 2 rope hooks with the 2 bolts.
8. INSTALL LUGGAGE COMPARTMENT NO. 1 TRIM COVER
a. Install the trim cover.
9. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
a. Install the floor mat.
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11. CHECK AND CLEAR DTC
a. Check and clear the DTCs.
12. PERFORM INITIALIZATION
a. Perform initialization.
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.