Distance Sensor: Service and Repair

Millimeter Wave Radar Sensor:

MILLIMETER WAVE RADAR SENSOR

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE ENGINE UNDER COVER
4. REMOVE FRONT FENDER LINER LH
5. REMOVE FRONT FENDER LINER RH
6. REMOVE FRONT BUMPER COVER




7. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
a. Disconnect the sensor connector.
b. Remove the 3 bolts and sensor.

INSTALLATION




1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
a. Install the sensor with the 3 bolts.

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)

b. Connect the sensor connector.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY
4. INSTALL FRONT BUMPER COVER
5. INSTALL FRONT FENDER LINER LH
6. INSTALL FRONT FENDER LINER RH
7. INSTALL ENGINE UNDER COVER
8. INSTALL COOL AIR INTAKE DUCT SEAL
9. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.