Transmission Mode Switch: Service and Repair
HYBRID MODE SELECT SWITCHCOMPONENTS (Part 1):
COMPONENTS (Part 2):
REMOVAL
1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT
2. REMOVE BATTERY SERVICE HOLE COVER LH
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
4. REMOVE SHIFT LEVER KNOB
5. REMOVE FRONT CONSOLE UPPER PANEL GARNISH
6. REMOVE UPPER CONSOLE PANEL ASSEMBLY
7. REMOVE INSTRUMENT PANEL FINISH PANEL END RH
8. REMOVE INSTRUMENT PANEL FINISH PANEL END LH
9. REMOVE CONSOLE BOX PLATE
10. REMOVE HYBRID MODE SELECT SWITCH
(a) Detach the 2 claws and remove the hybrid mode select switch from the console box plate.
INSPECTION
1. INSPECT HYBRID MODE SELECT SWITCH
(a) Measure the resistance according to the value(s) in the table.
Standard resistance:
If the resistance value is not as specified, replace the hybrid mode select switch.
INSTALLATION
1. INSTALL HYBRID MODE SELECT SWITCH
(a) Engage the 2 claws and install the hybrid mode select switch to the console box plate.
2. INSTALL CONSOLE BOX PLATE
3. INSTALL INSTRUMENT PANEL FINISH PANEL END LH
4. INSTALL INSTRUMENT PANEL FINISH PANEL END RH
5. INSTALL UPPER CONSOLE PANEL ASSEMBLY
6. INSTALL FRONT CONSOLE UPPER PANEL GARNISH
7. INSTALL SHIFT LEVER KNOB
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. INSTALL BATTERY SERVICE HOLE COVER LH
10. INSTALL LUGGAGE COMPARTMENT FLOOR MAT
11. PERFORM INITIALIZATION
(a) Perform initialization.
NOTICE:
Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.