Headlamp Alignment Sensor: Service and Repair

Height Control Sensor:

HEIGHT CONTROL SENSOR

REMOVAL

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed given are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY FRONT
a. Remove the front tire.
b. Disconnect the connector.

c. Remove the nut and height control sensor link from the lower arm.

d. Remove the 2 bolts and sensor.

3. REMOVE HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR
a. Remove the rear tire.
b. Disconnect the connector.

c. Put matchmarks on the sensor link and bracket.

d. Remove the 2 bolts and sensor.

INSTALLATION

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed given are for the LH side.

1. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY REAR

a. Install the height control sensor with the 2 bolts.

Torque: 13.5 N.m (138 kgf.cm, 10 ft.lbf)

b. Align matchmarks on the height control sensor and bracket.
c. Install the nut.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

d. Connect the connector.
e. Install the rear tire.

2. INSTALL HEIGHT CONTROL SENSOR SUB-ASSEMBLY FRONT

a. Install the height control sensor with the 2 bolts.

Torque: 13.5 N.m (138 kgf.cm, 10 ft.lbf)

b. Install the height control sensor link with the nut to the lower arm.

Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)

c. Connect the connector.
d. Install the front tire.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

4. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

5. ADJUST HEADLIGHT AIMING