Front Airbag Sensor

Front Airbag Sensor:

FRONT AIRBAG SENSOR

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE COOL AIR INTAKE DUCT SEAL
3. REMOVE FRONT BUMPER COVER
a. Remove the front bumper cover.

4. REMOVE HEADLIGHT ASSEMBLY
5. REMOVE FRONT AIRBAG SENSOR




a. Remove the 2 bolts and front airbag sensor from the body.
b. Disconnect the connector.

INSTALLATION

1. INSTALL FRONT AIRBAG SENSOR
a. Check that the power switch is OFF.
b. Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.




c. Connect the connector.
d Install the front airbag sensor with the 2 bolts.

Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)

NOTE:
- If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

e. Check that there is no looseness in the installation parts of the front airbag sensor.

2. INSTALL HEADLIGHT ASSEMBLY
3. INSTALL FRONT BUMPER COVER
a. Install the front bumper cover.

4. INSTALL COOL AIR INTAKE DUCT SEAL
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

7. INSPECT SRS WARNING LIGHT
8. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT
9. PREPARATION FOR HEADLIGHT AIMING
a. Preparation for headlight aiming.

10. HEADLIGHT AIMING INSPECTION
11. HEADLIGHT AIMING ADJUSTMENT
12. ADJUST FOG LIGHT AIMING