For Vehicles Equipped With TRAC and VSC System

FOR VEHICLES EQUIPPED WITH TRACTION CONTROL (TRAC) AND VEHICLE STABILITY CONTROL (VSC) SYSTEM

When testing with 2-wheel drum tester such as a speedometer tester, a combination tester for the speedometer and brake, a chassis dynamometer, or when jacking up the rear wheels and turning the wheels, enter the "MAINTENANCE MODE" with the intelligent tester and turn traction control off and the VSC system off.

CAUTION: If the vehicle is tested in normal mode on the drum tester, the traction control and VSC system may cause the vehicle to jump out from the drum tester.

NOTE:
- Check that the slip indicator light illuminates on the combination meter.
- For safety, secure the vehicle with restraint chains while using a drum tester.


a. Activating inspection mode:
1. Connect the intelligent tester to the DLC3.
2. Turn the power switch ON (IG).
3. Turn the intelligent tester ON.
4. Select from the tester menus: Powertrain, Hybrid Control, Active Test, Inspection mode - 2WD Inspection.




5. Check that "MAINTENANCE MODE" is displayed on the multi-information display.

HINT: The slip indicator light illuminates on the combination meter.

6. Begin testing.
7. Check that the "MAINTENANCE MODE" is deactivated and the slip indicator light turns off after testing.




CAUTION: Do not drive the vehicle if it is in "MAINTENANCE MODE".

b. Notices when using drum tester for the vehicle stability control system
1. Do not perform unnecessary installation and removal as it might affect the adjustment of VSC related parts.
2. Be sure to follow the instructions for work preparation and final confirmation of proper operation of the VSC system.