TC and CG Terminal Circuit

TC and CG Terminal Circuit

DESCRIPTION
The DTC output mode is set by connecting terminals TC and CG of DLC3.

The DTCs are displayed through blinking patterns of the absorber control indicator light.

Wiring Diagram:

Step 1-2:

Step 3:

Step 4-5:

Step 6-7:

INSPECTION PROCEDURE

NOTE:
- When replacing the absorber control ECU, check the acceleration sensor signal after replacement.
- If the hybrid control ECU has been replaced, it is necessary to register the ECU.

HINT: Check the condition of each related circuit connector before troubleshooting.