Body - Power Sliding Roof Initialization Procedure

PRE-DELIVERY SERVICE
PD013-06
REVISED

Title:
INITIALIZATION OF SLIDING ROOF
DURING PDS

Models:
'07 GS 450h

March 3, 2006

TSIB REVISION NOTICE:

^ December 4, 2006: Applicable Vehicles has been updated.

Previous versions of this TSIB should be discarded.

Introduction

Initialize the sliding roof after installing the DCC fuse in its original location during Pre-Delivery Service (PDS).

The installation of the DCC fuse, and the initialization procedure shown below, will enable the operation of the ~one-touch slide open and close " "one-touch tilt up and down," and "jam protection" functions of the sliding roof.

NOTE:
Any time the battery terminal has been disconnected, the sliding roof must be re-initialized.

Applicable Vehicles

^ 2007 model year GS 450h vehicles produced before July.

NOTE:
Initialization is NO longer necessary on GS 450h vehicles produced after July due to the addition of non-volatile memory.





Warranty Information





Initialization Procedure

1. Without depressing the brake pedal, push the engine START/STOP switch twice to select the "IG-ON" mode.

2. Push and hold the sliding roof switch to the "UP" side or the "CLOSE" side until the following cycle of the sliding roof operation is completed:

A. Closed position

B. Fully tilt up

C. Fully tilt down

D. Fully slide open

E. Fully slide close

After the cycle of operation above is completed, initialization is complete.

3. Check for proper operation of the "one-touch slide open and close" and "one-touch tilt up and down" functions by pushing the switch briefly to the "OPEN" and "UP" positions.

NOTE:
Jam protection is enabled through the above initialization procedure.