Backup Lamp: Service and Repair

Back-Up Light Assembly:

BACK-UP LIGHT ASSEMBLY

REMOVAL

HINT:
- Use the same procedures for the RH and LH side.
- The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.




2. REMOVE BACK-UP LIGHT LENS LH
a. Disconnect the connector.
b. Remove the 2 bolts and lens.

INSTALLATION

HINT:
- Use the same procedures for the RH and LH side.
- The procedures listed below are for the LH side.




1. INSTALL BACK-UP LIGHT LENS LH
a. Install the lens with the 2 bolts.
b. Connect the connector.

2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
3. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.