Removal and Installation

Headlight Assembly:

Headlight Assembly:

HEADLIGHT ASSEMBLY

REMOVAL

HINT:
- Use the same procedures for the RH and LH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

2. REMOVE RADIATOR GRILLE
3. REMOVE FRONT FENDER LINER LH
4. REMOVE FRONT FENDER LINER RH
5. REMOVE FRONT BUMPER ENERGY ABSORBER
6. REMOVE FRONT BUMPER COVER




7. REMOVE HEADLIGHT ASSEMBLY
a. Remove the 2 bolts, nut and clip.
b. Disconnect the connectors.




c. Pull out the unit in the direction indicated by the arrow in the illustration.

INSTALLATION

HINT:
- The procedures listed below are for the LH side.
- Use the same procedures for the RH and LH side.




1. INSTALL HEADLIGHT ASSEMBLY
a. Connect the connector.
b. Install the unit with the 2 bolts, nut and clip.

2. INSTALL FRONT BUMPER ENERGY ABSORBER
3. INSTALL FRONT BUMPER COVER
4. INSTALL FRONT FENDER LINER LH
5. INSTALL FRONT FENDER LINER RH
6. INSTALL RADIATOR GRILLE
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

8. PERFORM INITIALIZATION
a. Perform initialization.

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.

9. ADJUST HEADLIGHT AIMING