Without Scan Tool

CHECK DTC (USING SST CHECK WIRE)

a. Check the DTCs (present trouble code).




1. Turn the ignition switch ON and wait for approximately 60 seconds.
2. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST 09843-18040

NOTE: Connect the terminals correctly to avoid a malfunction.

b. Check the DTCs (past trouble code).

1. Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST 09843-18040

NOTE: Connect the terminals correctly to avoid a malfunction.

2. Turn the ignition switch ON and wait for approximately 60 seconds.

c. Read the DTCs.




1. Read the blinking patterns of the DTCs. Examples of the blinking patterns for the normal system code and DTCs 11 and 31 are shown in the illustration.

- Normal system code indication (w/o past trouble code): The light blinks twice per second.
- Normal system code indication (w/ past trouble code): When the past trouble code is stored in the center airbag sensor, the light blinks once per second.
- DTC indication: For DTC 11, the light illuminates for 0.5 seconds, turns off for 1.5 seconds, and then illuminates again for 0.5 seconds.

If there is more than 1 code, there will be a 2.5 second pause between each code. After all codes are shown, there will be a 4.0 second pause, and all codes will be repeated.

HINT: If 2 or more malfunctions are detected, the indication begins with the smaller numbered code.