For Vehicles Equipped With TRAC System and VSC System

FOR VEHICLES EQUIPPED WITH TRAC (TRACTION CONTROL) SYSTEM AND VSC (VEHICLE STABILITY CONTROL) SYSTEM




a. NOTICES FOR WHEN TESTING WITH 2-WHEEL DRUM TESTER
1. When testing with a 2-wheel drum tester such as a speedometer tester, a combination tester for the speedometer and brake, a chassis dynamometer, enter maintenance mode, or switch to VSC OFF mode to turn TRC and VSC operation off. Then enter test mode, start the engine and perform measurements.

CAUTION:
- If the vehicle is tested in normal mode on the drum tester, TRC and VSC operation may cause the vehicle to jump out from the drum tester.
- When switching to VSC OFF mode, the VSC OFF switch must be held for 3 seconds or more with the vehicle stopped. TRC and VSC operation must both be turned off before beginning testing.
- During VSC OFF mode, the combination meter's SLIP indicator light and VSC OFF indicator light illuminate.
- Fix the vehicle in place with chains for safety.

b. NOTICES FOR VSC RELATED PROCEDURES
1. For VSC related parts, adjustments are required after removal and installation. Therefore, perform removal and installation only when necessary.
2. When performing VSC related procedures, be sure to strictly follow the preparation and completion procedures.
3. When performing removal and installation or replacement of VSC related parts, first disconnect the cable from the negative (-) battery terminal