Crankshaft Main Bearing
CRANKSHAFTMain journal diameter 66.988 to 67.000 mm (2.6373 to 2.6378 in.)
Crank pin diameter 51.982 to 52.000 mm (2.0465 to 2.0472 in.)
Maximum taper and out of round 0.02 mm (0.0008 in.)
Crankshaft bearing cap bolt
Standard diameter 7.500 to 7.600 mm (0.2953 to 0.2992 in.)
Maximum diameter 7.20 mm (0.2835 in.)
CRANKSHAFT BEARING CAP
Install and uniformly tighten the 20 crankshaft bearing cap bolts in several passes in the sequence shown in the illustration.
Torque 27 N*m (275 kgf*cm, 20 ft.*lbf)
If any of the bearing cap bolts cannot meet the torque specification, replace the bearing cap bolt.
Mark the front of each crankshaft bearing cap bolt's head with paint.
Tighten the crankshaft bearing cap bolts another 90° as shown in the illustration.
Check that the painted mark is now at a 90° angle to the front.
Install a new seal washer to the crankshaft bearing cap bolt.
Install and uniformly tighten the 10 crankshaft bearing cap bolts.
Torque 49 N*m (500 kgf*cm, 36 ft.*lbf)