On-Vehicle Inspection

ON-VEHICLE INSPECTION

1. CHECK WINDOW LOCK SWITCH






a. Check that the passenger side power window operation is disabled when the window lock switch of the power window master switch is pressed.
b. Check that the passenger side power window can be operated when the window lock switch is pressed again.

2. CHECK MANUAL UP / DOWN FUNCTION
a. Check that the driver side power window operates as follows:






b. Check that the passenger side power window operates as follows:






3. CHECK AUTO UP / DOWN FUNCTION
a. Check that the driver side power window operates as follows:






b. Check that the passenger side power window operates as follows:






4. CHECK REMOTE MANUAL UP / DOWN FUNCTION
a. Check that the passenger side power window operates as follows:






5. CHECK REMOTE AUTO UP / DOWN FUNCTION
a. Check that the passenger side power window operates as follows:






6. CHECK JAM PROTECTION FUNCTION






HINT: The jam protection function prevents any part of your body from getting caught by accident between the door frame and the door glass during power window operation.

NOTICE: If the power window motor has just been reset, raise and lower the door glass several times using MANUAL UP / DOWN function before performing the check.

a. Check that the door glass goes down by approximately 50 mm (1.97 in.) immediately when something gets caught between the door frame and door glass during power window operation.

However, when the opening between the roof panel and the door glass is less than 200 mm (7.87 in.), the door glass continues to go down and does not stop until an opening of 200 mm (7.87 in.) is achieved. Operative conditions:
- AUTO UP
- AUTO UP / Manual UP function after the ignition switch is turned OFF
- Manual UP function using the driver side door lock key cylinder

7. CHECK MANUAL UP / DOWN FUNCTION USING DRIVER SIDE DOOR LOCK KEY CYLINDER
a. Check that all power windows operate as follows, when the key is inserted into the driver side door lock key cylinder.






8. CHECK MANUAL DOWN FUNCTION USING TRANSMITTER
a. Check that all power windows operate as follows when operating the transmitter.






9. CHECK POWER WINDOW OPERATION FUNCTION AFTER IGNITION SWITCH IS TURNED OFF
a. When both of the following conditions are fulfilled, check that the power windows can be operated even after the ignition switch is turned OFF.
1. Within 43 seconds after the ignition switch is turned OFF.
2. The front doors are closed.