Removal

INSTRUMENT PANEL: REAR CONSOLE BOX: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

2. REMOVE FRONT CONSOLE UPPER PANEL GARNISH
(a) Using a screwdriver, detach the claws and remove the garnish.
HINT: Tape the screwdriver tip before use.

3. REMOVE CONSOLE UPPER PANEL ASSEMBLY






(a) Turn the shift lever knob in the direction indicated by the arrow and remove it.






(b) Using a screwdriver, detach the 9 clips.
HINT: Tape the screwdriver tip before use.

(c) Remove the console upper panel and then disconnect the connector.
4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH






(a) Remove the screw.
(b) Using a screwdriver, detach the 3 clips and 3 claws.
HINT: Tape the screwdriver tip before use.

(c) Remove the finish panel end.
5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH






(a) Remove the screw.
(b) Using a screwdriver, detach the 4 clips and 3 claws.
HINT: Tape the screwdriver tip before use.

(c) Remove the finish panel end.
6. REMOVE CONSOLE BOX PLATE






(a) Using a screwdriver, detach the 4 clips.
HINT: Tape the screwdriver tip before use.

(b) Remove the console box plate and then disconnect the connector.
7. REMOVE CONSOLE BOX REGISTER ASSEMBLY






(a) Using a screwdriver, detach the 4 clips and remove the register.
HINT: Tape the screwdriver tip before use.

8. REMOVE CONSOLE BOX






(a) Remove the 4 bolts and 2 screws.
(b) Remove the console box and then disconnect the connector.