Audio and Visual System

AUDIO / VISUAL: AUDIO AND VISUAL SYSTEM: 01-D5: Absence of Registration Unit

DTC 01-D5 - Absence of Registration Unit

DTC 01-D8 - No Response for Connection Check

DTC 01-D9 - Last Mode Error

DTC 01-DA - No Response Against ON / OFF Command

DTC 01-DB - Mode Status Error

DTC 01-DE - Slave Reset

CAUTION / NOTICE / HINT
HINT: If the navigation type is NAVIGATION SYSTEM for HDD, "multi-display" refers to the "display and navigation assembly".

DESCRIPTION





HINT:
- *1: Even if no fault is present, this trouble code may be stored depending on the battery condition or hybrid system start voltage.
- *2: If the power connector is disconnected after the hybrid system starts, this code is stored after 180 seconds.
- *3: If it is reported that the device does not exist during verification, check the power source circuit and AVC-LAN circuit for the device.
NOTICE:
- Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
- The multi-display is the master unit.
- Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.

INSPECTION PROCEDURE
NOTE: Be sure to read the DESCRIPTION before performing the following procedures.

PROCEDURE

1. CHECK "DISPLAY AND NAVIGATION ASSEMBLY COMMUNICATION ERROR" IN FLOW CHART ("MULTI-DISPLAY COMMUNICATION ERROR" IN FLOW CHART)
(a) w/ Navigation System for HDD:
Refer to the display and navigation assembly communication error Display and Navigation Assembly Communication Error.
(b) w/ Navigation System for DVD or w/o Navigation System (w/ Multi-display):
Refer to the multi-display communication error Multi-Display Communication Error.
NEXT -- END