Installation

EXTERIOR: REAR BUMPER: INSTALLATION

INSTALLATION

1. INSTALL REAR LOWER BUMPER RETAINER LH
(a) Attach the 3 claws to install the retainer.
(b) Install the 5 screws.
2. INSTALL REAR LOWER BUMPER RETAINER RH
HINT: Use the same procedures described for the LH side.

3. INSTALL REAR UPPER BUMPER RETAINER LH
(a) Attach the 2 claws to install the retainer.
4. INSTALL REAR UPPER BUMPER RETAINER RH
(a) Attach the 2 clips to install the retainer.
(b) Attach the wire clamp.

5. INSTALL REAR BUMPER SIDE SUPPORT LH
(a) Attach the clip and 6 claws to install the side support.
(b) Install the 4 screws.
6. INSTALL REAR BUMPER SIDE SUPPORT RH
HINT: Use the same procedures described for the LH side.

7. INSTALL REAR NO. 1 BUMPER REINFORCEMENT
(a) Install the reinforcement with the 8 bolts.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)

8. INSTALL REAR BUMPER ARM REINFORCEMENT LH
(a) Attach the 6 claws to install the bumper arm reinforcement.
9. INSTALL REAR BUMPER ARM REINFORCEMENT RH
HINT: Use the same procedures described for the LH side.

10. INSTALL REAR BUMPER BAR
(a) Install the bumper bar to the energy absorber.

11. INSTALL REAR BUMPER ENERGY ABSORBER
(a) Install the energy absorber.
12. INSTALL REAR BUMPER COVER
(a) Connect the No. 3 floor wire connectors.

(b) Attach the 8 claws to install the rear bumper.

(d) Install the bumper seal bracket and attach the clip.
HINT: Use the same procedures for the RH side and LH side.

(e) Install the 6 screws and 6 clips.

13. INSTALL REAR BUMPER PLATE LH
(a) Attach the 3 claws to install the bumper plate.
HINT: Attach the claw on the inner side first.

14. INSTALL REAR BUMPER PLATE RH
HINT: Use the same procedures described for the LH side.

15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

16. INSTALL BATTERY SERVICE HOLE COVER LH Battery

17. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY