Installation

EXTERIOR: OUTSIDE MOULDING: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- When installing the moulding, heat the vehicle body and moulding using a heat light.

Standard heating temperature:





NOTE: Do not heat the vehicle body and moulding excessively.

1. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH
(a) Clean the vehicle body surface.
(1) Using a heat light, heat the vehicle body surface.
(2) Remove the double-sided tape from the vehicle body.
(3) Wipe off any tape adhesive residue with cleaner.
(b) If reusing the moulding:
Clean the moulding.
(1) Using a heat light, heat the moulding.
(2) Remove the double-sided tape from the moulding.
(3) Wipe off any tape adhesive residue with cleaner.





(4) Apply new double-sided tape to the moulding, as shown in the illustration.
(c) Install the moulding.
(1) Using a heat light, heat the vehicle body and moulding.
(2) Remove the peeling paper from the face of the moulding.
HINT: After removing the peeling paper, keep the exposed adhesive free from foreign matter.
(3) Attach the 2 clips to install the moulding.
HINT: Press the moulding firmly to install it.

2. INSTALL FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH
(a) Clean the vehicle body surface.
(1) Using a heat light, heat the vehicle body surface.
(2) Remove the double-sided tape from the vehicle body.
(3) Wipe off any tape adhesive residue with cleaner.
(b) If reusing the moulding:
Clean the moulding.
(1) Using a heat light, heat the moulding.
(2) Remove the double-sided tape from the moulding.
(3) Wipe off any tape adhesive residue with cleaner.
(4) Apply new double-sided tape to the moulding, as shown in the illustration.





(c) Install the moulding.
(1) Using a heat light, heat the vehicle body and moulding.
(2) Remove the peeling paper from the face of the moulding.
HINT: After removing the peeling paper, keep the exposed adhesive free from foreign matter.
(3) Attach the 6 clips to install the moulding.
HINT: Press the moulding firmly to install it.





(d) Install the nut and front door hole plug.
3. INSTALL REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH
(a) Clean the vehicle body surface.
(1) Using a heat light, heat the vehicle body surface.
(2) Remove the double-sided tape from the vehicle body.
(3) Wipe off any tape adhesive residue with cleaner.
(b) If reusing the moulding:
Clean the moulding.
(1) Using a heat light, heat the moulding.
(2) Remove the double-sided tape from the moulding.
(3) Wipe off any tape adhesive residue with cleaner.





(4) Apply new double-sided tape to the moulding, as shown in the illustration.
(c) Install the moulding.
(1) Using a heat light, heat the vehicle body and moulding.
(2) Remove the peeling paper from the face of the moulding.
HINT: After removing the peeling paper, keep the exposed adhesive free from foreign matter.
(3) Attach the 4 clips to install the moulding.
HINT: Press the moulding firmly to install it.





(d) Install the nut and rear door hole plug.