Climate Control Seat System

SEAT: CLIMATE CONTROL SEAT SYSTEM: DATA LIST / ACTIVE TEST

DATA LIST / ACTIVE TEST

1. READ DATA LIST
HINT: Using the intelligent tester or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Warm up the engine.
(b) Turn the power switch OFF.
(c) Connect the intelligent tester or Techstream to the DLC3.
(d) Turn the power switch ON (IG).
(e) Turn the tester on.
(f) Enter the following menus:
(1) Intelligent tester - Select: DIAGNOSIS / OBD/MOBD / (desired system) / DATA LIST / ALL.
(2) Techstream - Select: Body Electrical / (desired system) / Data List.
(g) According to the display on tester, read the "DATA LIST".
(1) Intelligent tester

FL SEAT A/C

FR SEAT A/C

RL SEAT A/C

RR SEAT A/C

CENTER CONSOLE

REAR CONSOLE

(2) Techstream

Front Left Seat A/C

Front Right Seat A/C

Rear Left Seat A/C

Rear Right Seat A/C

Center Console Switch

Rear Console Switch

2. PERFORM ACTIVE TEST
HINT: Using the intelligent tester or Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Warm up the engine.
(b) Turn the power switch OFF.
(c) Connect the intelligent tester or Techstream to the DLC3.
(d) Turn the power switch ON (IG).
(e) Turn the tester on.
(f) Enter the following menus:
(1) Intelligent tester - Select: DIAGNOSIS / OBD/MOBD / (desired system) / ACTIVE TEST.
(2) Techstream - Select: Body Electrical / (desired system) / Active Test.
(g) According to the display on tester, perform the "ACTIVE TEST".
(1) Intelligent tester

FL SEAT A/C