Reassembly

BRAKE: REAR BRAKE: REASSEMBLY

REASSEMBLY
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. TEMPORARILY INSTALL REAR DISC BRAKE BLEEDER PLUG
(a) Temporarily install the bleeder plug to the disc brake caliper.
HINT: The bleeder plug will be tightened to a torque specification in the "BLEED AIR FROM REAR BRAKE SYSTEM" procedure.

2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP
3. INSTALL PISTON SEAL
(a) Apply lithium soap base glycol grease to 2 new piston seals.






(b) Install the 2 piston seals to the disc brake caliper.
4. INSTALL REAR DISC BRAKE PISTON






(a) Apply lithium soap base glycol grease to the 2 rear disc brake pistons and 2 new cylinder boots.
(b) Install the 2 cylinder boots to the 2 rear disc brake pistons.
(c) Install the 2 pistons into the rear disc brake caliper.
NOTE: Do not forcibly install the piston into the disc brake caliper.

5. INSTALL CYLINDER BOOT






(a) Install one side of each of the 2 cylinder boots to the rear disc brake caliper.
- Install the cylinder boot securely to the grooves of the cylinder and piston.
- Do not damage the cylinder boot.