Installation

2UR-FSE ENGINE CONTROL SYSTEM: KNOCK SENSOR: INSTALLATION

INSTALLATION
HINT: When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.





1. INSTALL KNOCK SENSOR
(a) Install the 4 sensors with the 4 bolts so that the sensors are angled as shown in the illustration.
Torque: 20 Nm (204 kgf-cm, 15 ft-lbf)
HINT: The acceptable installation angle of the sensors is between 10° upwards and downwards from the horizontal position.

(b) Connect the 4 sensor connectors.
2. INSTALL SEPARATOR CASE





(a) Install the separator case with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)






(b) Connect the fuel pressure sensor connector.
3. INSTALL NO. 4 FUEL PIPE SUB-ASSEMBLY Installation

4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY Installation

5. INSTALL NO. 2 ENGINE COVER SUB-ASSEMBLY Installation

6. INSTALL NO. 2 ENGINE COVER SUB-ASSEMBLY LH Installation

7. INSTALL INTAKE MANIFOLD
(a) Install the intake manifold Installation.