Installation

SEAT BELT: CHILD RESTRAINT SEAT ANCHOR BRACKET: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart Standard Bolt - Specified Torque For Standard Bolts.

1. INSTALL CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY





(a) for Ottoman:
(1) for Passenger Side:
Install the anchor bracket with the 2 bolts.
Torque: 33 Nm (337 kgf-cm, 24 ft-lbf)





(2) for Driver Side:
Install the anchor bracket with the bolt.
Torque: 33 Nm (337 kgf-cm, 24 ft-lbf)






(b) for Power Seat, for Fixed Seat Type:
Align the claw with the positioning hole and install the 2 anchor brackets with the 2 bolts.
Torque: 33 Nm (337 kgf-cm, 24 ft-lbf)
2. INSTALL INNER CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY





(a) for Power Seat, for Fixed Seat Type:
(1) Align the hole with the positioning pin and install the 2 anchor brackets with the 2 bolts.
Torque: 33 Nm (337 kgf-cm, 24 ft-lbf)






(b) for Ottoman:
Align the hole with the positioning pin and install the anchor bracket with the bolt.
Torque: 33 Nm (337 kgf-cm, 24 ft-lbf)
3. INSTALL REAR SEAT ASSEMBLY
(a) for Power Seat:
Install the rear seat Installation.
(b) for Ottoman:
Install the rear seat Installation.
(c) for Fixed Seat Type:
Install the rear seat Installation.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. INSTALL BATTERY SERVICE HOLE COVER LH Battery

6. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY