Removal

METER: LIGHT CONTROL RHEOSTAT: REMOVAL

REMOVAL

1. DISABLE AUTO TILT AWAY FUNCTION
(a) Disable the AUTO TILT AWAY function by changing the customize parameter Repair Instruction - Customize Parameters.
NOTE: Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the current setting after finishing the operation.
HINT: Performing the above operation causes the AUTO TILT AWAY function to be disabled when the power switch is turned OFF.

(b) Turn the power switch ON (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.
(c) Turn the power switch OFF.
2. REMOVE INSTRUMENT SIDE PANEL LH Removal

3. REMOVE NO. 1 INSTRUMENT CLUSTER MOULDING Removal

4. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Removal

5. REMOVE STEERING COLUMN COVER (w/o Driver Monitor Camera) Removal

6. REMOVE STEERING COLUMN COVER (w/ Driver Monitor Camera) Removal

7. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY Removal

8. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal

9. REMOVE LIGHT CONTROL RHEOSTAT






(a) Detach the 2 claws and remove the rheostat.