Removal

POWER STEERING: DC / DC CONVERTER: REMOVAL

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

2. REMOVE BATTERY SERVICE HOLE COVER LH Battery

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

4. REMOVE BATTERY Removal

5. REMOVE BATTERY CARRIER Removal

6. REMOVE SERVICE PLUG GRIP
7. REMOVE ROPE HOOK

8. REMOVE ROPE HOOK ASSEMBLY

9. REMOVE DECK TRIM SIDE BOARD RH

10. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

11. REMOVE NO. 1 COOLER COVER (w/ Rear Cooler) Removal

12. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER

13. REMOVE REAR FLOOR FINISH PLATE

14. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH

15. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH

16. REMOVE POWER STEERING CONVERTER ASSEMBLY






(a) Remove the nut and clamp on the vehicle front side, and disconnect the 4 connectors.






(b) Remove the 4 nuts and converter.