Removal

SUSPENSION CONTROL: REAR ACCELERATION SENSOR: REMOVAL

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

2. REMOVE BATTERY SERVICE HOLE COVER LH Battery

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

4. REMOVE BATTERY SERVICE HOLE COVER

5. REMOVE ROPE HOOK

6. REMOVE ROPE HOOK ASSEMBLY

7. REMOVE DECK TRIM SIDE BOARD RH

8. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

9. REMOVE NO. 1 COOLER COVER (w/ Rear Cooler) Removal

10. REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER

11. REMOVE REAR FLOOR FINISH PLATE

12. REMOVE LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY RH

13. REMOVE ACCELERATION SENSOR ASSEMBLY






(a) Disconnect the connector.
(b) Remove the bolt and sensor with bracket.
NOTICE:
- Avoid any impact to the suspension control acceleration sensor.
- Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
- The acceleration sensor removed from the vehicle must not be placed upside down.