Removal

SUSPENSION CONTROL: HEIGHT CONTROL SENSOR (for Front LH): REMOVAL

REMOVAL
CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing Suspension Control System.
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

2. REMOVE BATTERY SERVICE HOLE COVER LH Battery

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

4. REMOVE FRONT WHEEL LH
5. DISCONNECT SKID CONTROL SENSOR WIRE






(a) Remove the bolt and detach the 2 clips.
6. REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH






(a) Disconnect the connector.






(b) Remove the bolt and disconnect the height control sensor link from the front No. 2 suspension lower arm LH.






(c) Remove the 2 bolts and height control sensor.
NOTE: Do not drop the height control sensor. If it is dropped, replace it with a new one.