Removal

SUSPENSION CONTROL: FRONT ACTIVE STABILIZER CONTROL ECU: REMOVAL

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

2. REMOVE BATTERY SERVICE HOLE COVER LH Battery

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

4. REMOVE SERVICE PLUG GRIP Removal

5. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal

6. REMOVE ENGINE ROOM SIDE COVER LH Removal

7. REMOVE ENGINE ROOM SIDE COVER RH Removal

8. REMOVE COOL AIR INTAKE DUCT SEAL Removal

9. REMOVE FRONT FENDER WHEEL OPENING MOULDING LH

10. REMOVE FRONT FENDER WHEEL OPENING MOULDING RH Removal

11. REMOVE RADIATOR GRILLE ASSEMBLY Removal

12. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH Removal

13. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH Removal

14. REMOVE FRONT FENDER LINER LH Removal

15. REMOVE FRONT FENDER LINER RH Removal

16. REMOVE FRONT BUMPER COVER Removal

17. REMOVE NO. 1 ENGINE UNDER COVER
(a) Remove the 9 screws, 7 clips and under cover.
18. DISCONNECT FRONT FENDER LINER LH






(a) Remove the 3 screws.
(b) Partially remove the fender liner.
HINT: It is not necessary to fully remove the fender liner. Partially remove it so that the ECU can be removed.

19. REMOVE HEADLIGHT ASSEMBLY LH
(a) for HID Headlight:
Remove the headlight Removal.
(b) for LED Headlight:
Remove the headlight Removal.
20. DRAIN WASHER FLUID Removal

21. REMOVE WASHER INLET SUB-ASSEMBLY Removal

22. REMOVE WINDSHIELD WASHER JAR ASSEMBLY Removal

23. REMOVE NO. 3 COOL AIR INTAKE DUCT SUB-ASSEMBLY






(a) Detach the clamp and remove the 2 bolts.






(b) Detach the 2 claws and remove the duct.






24. REMOVE INLET ENGINE ROOM ECM DUCT
(a) Remove the duct from the ECM box.
25. DISCONNECT FRONT ACTIVE STABILIZER CONTROL ACTUATOR CONNECTOR






(a) Disconnect the wire harness clamp.
(b) Disconnect the actuator connector labeled A.
(c) Disconnect the actuator connector labeled B.
(1) Release the lever's lock. (*1)
(2) Press the claw and move the lever in the direction of the arrow in the illustration. (*2)
(3) Disconnect the actuator connector. (*3)
NOTE: When disconnecting the actuator connector, do not apply excessive force to the wire harness.

26. REMOVE FRONT ACTIVE STABILIZER CONTROL ECU






(a) Remove the 3 bolts and ECU.






(b) Disconnect the ECU connector.
(1) Release the lever's lock. (*1)
(2) Press the claw and move the lever in the direction of the arrow in the illustration. (*2)
(3) Disconnect the ECU connector. (*3)
NOTE: When disconnecting the ECU connector, do not apply excessive force to the wire harness.