Body - Rubbing Noise From Rear Of Vehicle

L-SB-0070-11

August 25, 2011

Rear Wheel Rocker Panel Protector Loose

Service Category
Vehicle Exterior

Section
Exterior Panels/Trim

Market
USA





Applicability

Introduction

Some 2007 - 2009 LS 460/460L and 2008-2009 LS 600h models may exhibit a rubbing noise from the rear of the vehicle due to the rocker panel molding protector coming loose. The following repair procedures have been developed to reinstall the molding and address this condition.





Production Change Information

This TSIB applies to vehicles produced BEFORE the Production Change Effective VINs shown.





Parts Information





Warranty Information

Repair Procedure





1. Remove the rocker panel molding protector.

A. Using a clip remover remove the 2 clips.

B. Remove the screw and protector.





2. Measure and mark the dimensions on the rocker panel molding as shown in the illustration.





3. Drill 2 pilot holes 3 mm (1/8 inch) on the rocker panel at the location shown.





4. Using a utility knife cut the rocker panel molding using the lines marked as a guide.





5. Slide the clip onto the rocker panel molding as shown in the illustration so that the clip lines up with the mounting hole.

6. Attach the rocker panel protector to the rocker panel molding using the new screw.