Canada - Body - Auto Door Closer Inoperative
BulletinTSB2812
Issue Date
August 3, 2010
Title
AUTO DOOR CLOSER INOPERATIVE
Component
BODY COMPONENTS
Models
'07-'08 LS460, LS600h
INTRODUCTION:
Some 2007 - 2008 model year LS460, LS460L, and LS600h vehicles may exhibit a condition where the Auto Door Closer function is inoperative. The coating material on the weatherstrip has been changed to address this condition.
This bulletin provides information to replace the No. 2 door weatherstrip on the affected door.
APPLICABILITY:
PRODUCTION CHANGE INFORMATION:
This TSB applies to vehicles produced BEFORE the Production Change Effective VIN shown.
WARRANTY INFORMATION:
PARTS INFORMATION:
REPAIR PROCEDURE:
Front Door No. 2 Weatherstrip Removal
1. Remove the clip.
2. Remove the Front Door No. 2 Weatherstrip.
Carefully remove the No. 2 door seal.
HINT
Double-sided tape is used to retain the door seal at the front edge of the door.
Front Door No. 2 Weatherstrip Installation
1. Clean the front door surface.
Remove and clean any of the remaining double-sided tape and adhesive residue from the door.
2. Install the NEW Front Door No. 2 Weatherstrip.
A. Remove the protective strip from the adhesive tape.
B. Install the No. 2 door seal ensuring that the seal lips engage into the door frame.
C. Reinstall the clip.
3. Check door and door closer for proper operation.
Rear Door No. 2 Weatherstrip Removal
1. Remove the clip.
2. Remove the Front Door No. 2 Weatherstrip.
Carefully remove the No. 2 door seal.
HINT
Double-sided tape is used to retain the door seal at the rear edge of the door and along the lower front edge of the door.
Rear Door No. 2 Weatherstrip Installation
1. Clean the rear door surface.
Remove and clean any of the remaining double-sided tape and adhesive residue from the door.
2. Install the NEW Rear Door No. 2 Weatherstrip.
A. Remove the protective strip from the adhesive tape.
B. Install the No. 2 door seal ensuring that the seal lips engage into the door frame.
C. Install the clip.
3. Check door and door closer for proper operation.
NOTE:
Issue of this Technical Service Bulletin is to ensure that proper repair information is available. IT DOES NOT CONSTITUTE AN AUTHORIZATION FOR REPAIR. Normal provisions of the formal warranty policy, as applicable, will apply.