Installation

L110F HYBRID TRANSMISSION / TRANSAXLE: OIL PUMP MOTOR CONTROLLER: INSTALLATION

INSTALLATION

1. INSTALL OIL PUMP MOTOR CONTROLLER
CAUTION: Be sure to perform the procedure as described below. Do not turn the power switch on (READY) before reconnecting the cable to the negative battery terminal.

(a) Install the oil pump motor controller with the 3 bolts.
Torque: 6.0 Nm (61 kgf-cm, 53 in-lbf)

(b) Install the clamp to the bracket.

(d) Connect the connector and securely lock the lock lever as shown in the illustration.
- Be sure to securely lock the claw on the connector.
- Push the connector all the way in and lock the lock lever.
HINT: When the connector is pushed all the way in, the lock lever will move slightly to the lock position.

(e) Push in the lever to securely engage the lock on the connector.

(f) Connect the connector to the oil pump motor controller.

(g) Connect the connector and securely lock the lock lever as shown in the illustration.
- Be sure to securely lock the claw on the connector.
- Push the connector all the way in and lock the lock lever.
HINT: When the connector is pushed all the way in, the lock lever will move slightly to the lock position.

(h) Push the lock into the lock lever to securely lock the lock lever on the connector.
2. INSTALL NO. 1 AIR CLEANER INLET Installation

3. INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY Installation

4. INSTALL ENGINE ROOM SIDE COVER RH Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

6. INSTALL BATTERY SERVICE HOLE COVER LH Battery

7. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY