Removal

L110F HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: REMOVAL

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

2. REMOVE BATTERY SERVICE HOLE COVER LH Battery

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the power switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

4. REMOVE FRONT FLOOR COVER CENTER Removal

5. REMOVE NO. 2 ENGINE UNDER COVER Removal

6. SEPARATE OIL COOLER TUBE






(a) Remove the 3 bolts and separate the oil cooler tube.
7. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
(a) Set the shift lever to the neutral position.






(b) Remove the nut, and separate the floor shift gear shifting rod sub-assembly.
8. REMOVE PARK/NEUTRAL POSITION SWITCH






(a) Disconnect the park/neutral position switch connector.






(b) Remove the nut, washer and transmission control shaft lever.






(c) Using a screwdriver, pry out the lock washer.
(d) Remove the lock nut and lock washer.






(e) Remove the 2 bolts and park/neutral position switch.