Component Tests and General Diagnostics

WINDSHIELD / WINDOWGLASS: POWER WINDOW CONTROL SYSTEM: OPERATION CHECK

OPERATION CHECK





1. CHECK WINDOW LOCK SWITCH
(a) Check that the front passenger side power window and the rear power windows cannot be operated when the window lock switch of the master switch assembly is pressed.
OK:
Operation of front passenger side power window and rear power windows are disabled.
(b) Check that the front passenger side power window and the rear power windows can be operated when the window lock switch is pressed again.
OK:
Front passenger side power window and rear power windows can be operated.

2. CHECK MANUAL UP / DOWN FUNCTION
(a) Check that the driver side power window operates as follows:

OK





(b) Check that the front passenger side and rear power windows operate as follows:

OK





3. CHECK AUTO UP / DOWN FUNCTION
(a) Check that the driver side power window operates as follows:

OK





(b) Check that the front passenger side and rear power windows operate as follows:

OK





4. CHECK REMOTE MANUAL UP / DOWN FUNCTION
(a) Check that the front passenger side and rear power windows operate as follows:

OK





5. CHECK REMOTE AUTO UP / DOWN FUNCTION
(a) Check that the front passenger side and rear power windows operate as follows:

OK





6. CHECK POWER WINDOW OPERATION FUNCTION AFTER POWER SWITCH OFF
(a) Check that all the power windows can be operated with the master switch after the power switch is turned OFF.
(b) Check that the key-off operation function does not operate after a front side door is opened.
(c) Check that all the power windows cannot be operated after more than approximately 45 seconds have elapsed since the power switch is turned OFF.
7. CHECK TRANSMITTER-LINKED FUNCTION
(a) Check that all power windows operate as follows when operating the transmitter.

OK





8. CHECK KEY-LINKED FUNCTION USING DRIVER SIDE DOOR KEY CYLINDER
(a) Check that all power windows operate as follows.

OK





9. CHECK AUTO UP FUNCTION USING ENTRY LOCK SWITCH
(a) Check that all power windows operate as follows when the entry lock switch is pressed and held.

OK





10. CHECK JAM PROTECTION FUNCTION
(a) Check the basic function.
CAUTION:
- The jam protection function is operative during both the AUTO UP and MANUAL UP operation.
- Do not put your fingers between the door frame and door glass to check functions. Also, prevent any part of your body from being caught during inspection.
HINT: The jam protection function is operative during both AUTO UP and MANUAL UP operation while the engine is running or the power switch is ON (IG), and also 45 seconds after the power switch is turned OFF.
(1) Fully open the window.





(2) Set a thick book wrapped with a cloth or piece of cloth near the power window fully closed position.
(3) Operate the AUTO UP or MANUAL UP function to check that the power window goes down before the book is caught between the window and door frame, and stops when the opening reaches approximately 200 mm (7.87 in.).
HINT: The power window moves down approximately 125 mm (4.93 in.). However, when the opening does not reach 200 mm (7.87 in.), the power window continues to go down until the opening reaches 200 mm (7.87 in.) or until approximately 5 seconds have elapsed.
(4) While the power window is moving down, check that the door glass cannot be moved up even when the power window switch is used.
11. CHECK POWER WINDOW SWITCH LED ILLUMINATION
(a) Check the LED illumination.
(1) Check that the LED located on the power window switch illuminates when the power switch is ON (IG) and the window lock switch is set to the UNLOCK position.