Rear Sunshade System

INTERIOR: REAR SUNSHADE SYSTEM: DATA LIST / ACTIVE TEST

DATA LIST / ACTIVE TEST

1. DATA LIST
HINT: Using the intelligent tester or Techstream to read the Data List allows the values or states of switches, sensor, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may by discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the intelligent tester or Techstream to the DLC3.
(b) Turn the power switch ON (IG).
(c) Turn the tester on.
(d) Enter the following menus:
(1) Intelligent tester - Select: DIAGNOSIS / OBD/MOBD / (desired menu) / DATA LIST / ALL.
(2) Techstream - Select: Body Electrical / (desired menu) / Data List.
(e) According to the display on tester, read the "Data List".
(1) Intelligent tester

CENTER CONSOLE





REAR CONSOLE





BODY NO. 4





(2) Techstream

Center Console Switch





Rear Console Switch





Body No. 4





2. ACTIVE TEST
HINT: Using the intelligent tester or Techstream to Perform the Active Tests allows relays, VSVs and actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
NOTE: When a Body No. 4 (luggage room junction block) related vehicle switch is ON, Active Test items related to the vehicle switch are prohibited (double operation prohibition). Check that the vehicle switches are OFF before performing Active Tests.

(a) Connect the intelligent tester or Techstream to the DLC3.
(b) Turn the power switch ON (IG).
(c) Turn the tester on.
(d) Enter the following menus:
(1) Intelligent tester - Select: DIAGNOSIS / OBD/MOBD / BODY NO. 4 / ACTIVE TEST.
(2) Techstream - Select: Body Electrical / Body No. 4 / Active Test.
(e) According to the display on tester, perform the "Active Test".
(1) Intelligent tester

BODY NO. 4





(2) Techstream

Body No. 4