Installation

EXTERIOR: FRONT BUMPER:

INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY





(a) Connect each connector.
(b) Engage each claw.
(c) Install the front bumper assembly with the 9 screws, 2 clips, 2 radiator grille protectors and bolt.
Screw (A) - Torque: 2.0 Nm (20 kgf-cm, 18 in-lbf)





(d) Install the 2 pin hold clips.
HINT: Use the same procedures for the RH side and LH side.

2. INSTALL COOL AIR INTAKE DUCT SEAL





(a) Install the cool air intake duct seal with the 7 clips.
3. VEHICLE PREPARATION FOR FOG LIGHT AIMING Adjustments
4. PREPARATION FOR FOG LIGHT AIMING Adjustments
5. INSPECT FOG LIGHT AIMING Adjustments
6. ADJUST FOG LIGHT AIMING Adjustments