Installation

DOOR LOCK: ENTRY LOCK AND UNLOCK SWITCH (for Front Side):

INSTALLATION

1. INSTALL FRONT DOOR OUTSIDE HANDLE SUB-ASSEMBLY





(a) Insert the front end of the front door outside handle assembly into the front door outside handle frame.
(b) Insert the rear end of the front door outside handle assembly into the front door outside handle frame. Next, slide the front door outside handle assembly toward the front of the vehicle to install it.





(c) Using a "TORX" socket wrench (T30), install the front door handle assembly outside with the screw.
Torque: 4.0 Nm (41 kgf-cm, 35 in-lbf)
(d) Connect the connector.
2. INSTALL FRONT DOOR OUTSIDE HANDLE COVER Reassembly
3. INSTALL FRONT DOOR SERVICE HOLE COVER Reassembly
4. INSTALL FRONT NO. 1 DOOR TRIM BRACKET Reassembly
5. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY Installation
6. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP Reassembly
7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY Reassembly
8. INSTALL DOOR ARMREST COVER Reassembly
9. INSTALL COURTESY LIGHT ASSEMBLY Reassembly
10. INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY Reassembly
11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG Reassembly