Brake

BRAKE: STOP LIGHT SWITCH:

INSTALLATION

1. INSTALL STOP LIGHT SWITCH





(a) Insert the stop light switch until the body hits the cushion.
NOTE:
When inserting the stop light switch, support the pedal from behind so that the pedal is not pushed in.





(b) Make a quarter turn clockwise to install the stop light switch.
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf)
NOTE:
When inserting the stop light switch, support the pedal from behind so that the pedal is not pushed in.





(c) Connect the stop light switch connector to the stop light switch.
(d) Check the protrusion of the rod On-Vehicle Inspection.
2. INSTALL COMBINATION METER Installation
3. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Installation
4. INSTALL FRONT DRIVER SIDE KNEE AIRBAG ASSEMBLY Installation
5. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY Installation
6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
7. INSTALL INSTRUMENT SIDE PANEL LH Installation
8. INSTALL FRONT DOOR OPENING TRIM COVER LH Installation
9. INSTALL FRONT DOOR SCUFF PLATE OUTSIDE LH Installation
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

11. INSPECT SRS WARNING LIGHT
HINT: Diagnosis System