Front Axle Hub

AXLE: FRONT AXLE HUB:

ON-VEHICLE INSPECTION

1. REMOVE FRONT WHEEL
2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY Removal
3. REMOVE FRONT DISC Disassembly
4. INSPECT FRONT AXLE HUB BEARING LOOSENESS





(a) Using a dial indicator, check for looseness near the center of the axle hub.
Maximum:
0.05 mm (0.0020 in.)
NOTE:
Ensure that the dial indicator is set perpendicular to the measurement surface.
HINT: If looseness exceeds the maximum, replace the bearing.

5. INSPECT FRONT AXLE HUB RUNOUT





(a) Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
Maximum:
0.05 mm (0.0020 in.)
NOTE:
Ensure that the dial indicator is set perpendicular to the measurement surface.
HINT: If runout exceeds the maximum, replace the axle hub.

6. INSTALL FRONT DISC Reassembly
7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY Installation
8. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)