Installation

SUPPLEMENTAL RESTRAINT SYSTEM: REAR AIRBAG SENSOR:

INSTALLATION

1. INSTALL REAR AIRBAG SENSOR
(a) Check that the engine switch is off.
(b) Check that the battery negative (-) cable is disconnected.
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.





(c) Install the rear airbag sensor with the bolt.
Torque: 9.0 Nm (92 kgf-cm, 80 in-lbf)
- If the rear airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the rear airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the rear airbag sensor.
(e) Connect the connector.
2. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY (w/ Rear Seat Side Airbag) Installation
3. INSTALL REAR SEAT SIDE GARNISH (w/o Rear Seat Side Airbag) Installation
4. INSTALL REAR DOOR SCUFF PLATE (w/ Rear Seat Side Airbag) Installation
5. INSTALL REAR DOOR SCUFF PLATE (w/o Rear Seat Side Airbag) Installation
6. INSTALL REAR SEATBACK ASSEMBLY (w/ Rear Seat Side Airbag) Installation
7. INSTALL REAR SEAT CUSHION ASSEMBLY (w/ Rear Seat Side Airbag) Installation
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. PERFORM INITIALIZATION
(a) Perform initialization Repair Instruction - Initialization.
HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal.

10. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light Diagnosis System.