Removal

BRAKE CONTROL: SKID CONTROL SENSOR:

REMOVAL
HINT:
- Use the same procedure for the RH side and LH side.
- The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL
2. DISCONNECT SKID CONTROL SENSOR WIRE





(a) Disconnect the connector from the skid control sensor.
NOTE:
Be careful not to damage the skid control speed sensor.

3. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY Removal
4. REMOVE REAR DISC Disassembly
5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY WITH SKID CONTROL SENSOR Removal
6. REMOVE SKID CONTROL SENSOR





(a) Mount the rear axle hub and bearing assembly in a vise using aluminum plates.
NOTE:
Replace the rear axle hub and bearing assembly if it is dropped or receives a strong shock.

(b) Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST.
SST: 09520-00031
09521-00010
09520-00040
SST: 09521-00020
(c) Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub and bearing assembly.
SST: 09520-00031
09521-00010
09520-00040
SST: 09521-00020
SST: 09950-00020
NOTICE:
- Keep the skid control sensor away from magnets.
- Pull the skid control sensor off straight, taking care not to make contact with the skid control sensor rotor.
- If the skid control speed sensor rotor is damaged or deformed, replace the rear axle hub and bearing assembly.
- Do not scratch the contact surface between rear axle hub and bearing assembly and the skid control sensor.
- Do not attach foreign matter to the skid control speed sensor rotor and tip.