Installation

BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR:

INSTALLATION

1. INSTALL YAW RATE AND ACCELERATION SENSOR





(a) Install the yaw rate and acceleration sensor with the 2 bolts.
Torque: 13 Nm (133 kgf-cm, 10 ft-lbf)
- Do not damage the yaw rate and acceleration sensor.
- Make sure that the yaw rate and acceleration sensor is installed securely.

(b) Connect the yaw rate and acceleration sensor connector and clamp.
2. INSTALL NO. 3 CONSOLE BOX DUCT Installation
3. INSTALL REAR CONSOLE BOX ASSEMBLY Installation
4. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY Installation
5. INSTALL CONSOLE BOX CARPET Installation
6. INSTALL CONSOLE POCKET Installation
7. INSTALL INSTRUMENT PANEL FINISH END PANEL LH Installation
8. INSTALL INSTRUMENT PANEL FINISH END PANEL RH Installation
9. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY WITH FRONT ASH RECEPTACLE Installation
10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation
11. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
HINT: Programming and Relearning

12. INSPECT SENSOR SIGNAL
HINT: Test Mode Procedure