Data List / Active Test

L110 HYBRID VEHICLE CONTROL: HYBRID CONTROL SYSTEM: DATA LIST / ACTIVE TEST

DATA LIST / ACTIVE TEST

1. DATA LIST
NOTICE:
- Some data list values may vary significantly if there are slight differences in the environment in which the vehicle is operating when measurements are obtained. Variations may also occur due to aging of the vehicle. Due to these considerations, it is not always possible to provide definite values to be used for judgment of malfunctions. It is possible that a malfunction may be present even if measured values are within the reference range.
- In the event of a problem with intricate symptoms, collect sample data from another vehicle of the same model operating under identical conditions in order to reach an overall judgment by comparing all the items in the data list.
HINT: Using the Techstream to read the data list allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the data list information early in troubleshooting is one way to save diagnostic time.

(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG) and turn the Techstream on.
(c) Select the following menu items: Powertrain / Hybrid Control / Data List.
(d) Check the results by referring to the following table.

DATA LIST:









































2. ACTIVE TEST
HINT: Using the Techstream to perform active tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing active tests early in troubleshooting is one way to save diagnostic time. Data list information can be displayed while performing active tests.
NOTICE:
It is necessary to use caution, because if the Techstream DLC connector becomes disconnected or if a communication error occurs during an active test, the vehicle could become inoperative (the READY light may go off).

(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG) and turn the Techstream on.
(c) On the system selection screen, enter the following menus: Powertrain / Hybrid Control / Active Test.
(d) According to the display on the tester, perform the appropriate active test.

ACTIVE TEST:





NOTICE:
- For items marked with *1 in the chart, Enter inspection mode Component Tests and General Diagnostics.
- For items marked with *2 in the chart, the Techstream will display a communication error and the vehicle's READY light will turn off when the active test is completed. If the tester will be used on the vehicle again, turn the power switch off and then on (READY) again to restart the tester.
- For items marked with *3 in the chart, the OIL PMP active test can be performed for 30 seconds. A one minute interval is required between active tests.
- For items marked with *4: If the active test is prohibited, turn the power switch off and then back on (READY). After turning the power switch back on (READY), perform the active test again.